 |
For RAMs equipped with the factory
infinity speaker you will have to
cut the strain relief (arrow) to
give the wire some more slack.
Remove the speaker by gently
pressing on it's retaining clips and
then remove the speaker grille.
The new gauge mount will be attached
to the factory pillar. The
gauge mount instructions require you
to grind out the speaker nub (bump).
If you would like to avoid this,
simply purchase a new factory
A-Pillar with out the speaker option
(Mopar Part #: 5ES57LAZ). You can
attach the gauge mount to this new
pillar and retain you factory
pillar for future reinstallation.
Snap in the factory pillar and hold the gauge mount over the
factory pillar. Hold it up
tight against the headliner.
Press the door molding back into
place and mark a location with a
pencil for the 2 fasteners (one top
and one bottom). While holding
the gauge mount up tight against the
headliner, drill 2 holes with a
3/16" drill bit for the fasteners. You will be
drilling the other 2 fastener holes
(windshield side) later.
Remove the gauge mount and factory
pillar, line up the 2 drilled holes
(insert screws to prevent shifting
between the two) and drill the 2
remaining windshield side holes. |
|
 |
|